Tag Archives: LED controller

Why Are NovaStar CVT10 Ports 9 and 10 Unavailable?

NovaStar CVT10-M front panel and Ethernet indicators for CVT10 ports 9 and 10 checks

CVT10 ports 9 and 10 can be unavailable because usable Ethernet-port count depends on the connected sending equipment and conversion direction. In the retained V1.2.2 specification, fiber input from an eight- or sixteen-port device makes the first eight CVT10 Ethernet ports available; a ten- or twenty-port device supports all ten. Confirm the sender and firmware […]

NovaStar MCTRL600 vs MCTRL660 PRO: Signal-Chain Selection

NovaStar MCTRL600 front panel for MCTRL600 vs MCTRL660 PRO selection

An MCTRL600 vs MCTRL660 PRO choice should follow the source and signal-routing requirements. MCTRL600 provides HDMI/DVI input and four Gigabit LED outputs; MCTRL660 PRO adds 3G-SDI, six Gigabit ports, optical connections, input monitoring and documented synchronization features. Check the exact source timing, bit depth and firmware conditions before treating either controller as suitable. This guide […]

NovaStar DH7512-S vs DH7516-S: HUB75E and Cabinet Selection

NovaStar DH7512-S board with twelve HUB75E connectors

The practical DH7512-S vs DH7516-S difference is the module-output arrangement: twelve HUB75E connectors and up to 24 parallel RGB groups on DH7512-S, versus sixteen connectors and up to 32 groups on DH7516-S. The cited later specifications give both cards the same driver-dependent loading dimensions. More sockets do not automatically mean more total screen pixels or […]

NovaStar A10s Plus vs A10s Pro: Revision and Compatibility Guide

NovaStar A10s Plus component side and model label for A10s Plus vs A10s Pro selection

An A10s Plus vs A10s Pro choice depends on the exact cabinet, required image functions and supported controller combination. Both families use compact high-density connections, but a shared nominal pixel capacity does not establish that they are interchangeable. The Pro documents additional calibration functions, while electrical and mechanical parameters must be checked against the supplied […]

NovaStar AD20 Playback: Synchronous or Asynchronous Mode?

NovaStar AD20 board and labeled connections for NovaStar AD20 playback checks

NovaStar AD20 playback can use an internal media source in asynchronous mode or an HDMI input in synchronous mode. Choose internal playback for prepared signage content and HDMI input for a supported live source. Both modes remain subject to the AD20’s 1.3-million-pixel LED load and the documented source-format conditions. This guide is for a small […]

NovaStar CMS130 vs CMS260: Inputs, Pixel Load and Playback

NovaStar CMS130 front and rear panels for CMS130 vs CMS260 selection

In a CMS130 vs CMS260 decision, choose the CMS130 when a screen within its published 1.3-million-pixel limit needs DVI, VGA, CVBS or documented USB media playback. Consider the CMS260 when the project needs up to 2.6 million pixels, four LED outputs, 3G-SDI or two image layers. Confirm the source format and output map before ordering […]