When checking a replacement HUB card, compare its revision and numbered signals with the module documentation. On the QP-HUB54-V2.0, the RGB groups run consecutively from R1 on pin 1 through B5 on pin 15.
Interface pinout
| Pin | Signal | Pin | Signal |
|---|---|---|---|
| 1 | R1 | 2 | G1 |
| 3 | B1 | 4 | R2 |
| 5 | G2 | 6 | B2 |
| 7 | R3 | 8 | G3 |
| 9 | B3 | 10 | R4 |
| 11 | G4 | 12 | B4 |
| 13 | R5 | 14 | G5 |
| 15 | B5 | 16 | GND |
| 17 | A | 18 | B |
| 19 | C | 20 | D |
| 21 | GND | 22 | CLK |
| 23 | GND | 24 | LAT |
| 25 | GND | 26 | OE |
Board photos


Frequently asked questions
Which pins carry the address signals?
A, B, C and D are on pins 17, 18, 19 and 20 respectively. Pin 16, immediately before that group, is ground.
Where are CLK, LAT and OE on the QP-HUB54-V2.0?
CLK is pin 22, LAT is pin 24 and OE is pin 26. The intervening pins 23 and 25 are ground, as is pin 21.
Can I substitute another 26-pin HUB card?
The connector pin count alone does not establish compatibility. Match the numbered data, address, control and ground signals to the module’s requirements.











Reviews
There are no reviews yet.