A704 receiving card with display processing functions
The Mooncell A704 is a four-interface HUB75E receiving card for LED cabinets. Alongside AutoLED configuration and pixel-level calibration, it supports 18Bit+, independent RGB gamma adjustment and bright/dark seam adjustment for display setup.
HDR, 3D and low-latency operation have specific source, controller or driver requirements. The table keeps those conditions alongside the features and separates conventional-driver loading from PWM-driver loading.
Technical specifications
| Parameter | Specification |
|---|---|
| Model / specification | Mooncell A704; V3.0 document for A704 hardware V1.0 |
| Module interfaces | 4 × HUB75E |
| Parallel RGB output | 8 groups |
| Conventional-driver loading | Maximum, brightness correction and chromaticity correction: 256 × 256 pixels |
| PWM-driver loading | Maximum and brightness correction: 512 × 256; chromaticity correction: 256 × 320 pixels |
| Scan support / cascade limit | 1–64 scan / ≤1,000 cards |
| 18Bit+ | Software-enabled function described as a fourfold grayscale increase, intended to improve low-brightness grayscale performance |
| HDR formats | HDR10 and HLG with a compatible high-capacity independent controller and matching source |
| Low-latency condition | As low as 1 frame at the receiving-card end for modules using driver ICs with built-in RAM |
| 3D condition | Set the receiving-card frame rate to 120 Hz and use an independent controller supporting 3D, with 3D enabled and configured |
| RGB gamma | Independent RGB gamma adjustment with compatible controller and software |
| Calibration / seam adjustment | Pixel-level brightness and chromaticity correction; software adjustment of bright/dark module and cabinet seams |
| Layout and image controls | AutoLED custom outputs, complex cabinet mapping, 90°-increment rotation and scaling |
| Diagnostics | Card sequence detection, configuration readback, cable error-rate detection and communication monitoring |
| Cable backup | Primary/backup network cable loop |
| Input voltage | DC 3.5–5.5 V |
| Rated current / power | 0.6 A / 3 W |
| Operating conditions | −20 to 70°C; 10–90% RH |
| Storage temperature | −25 to 125°C |
| Board dimensions / net weight | 120.0 × 50.0 mm / 50 g |
Product images and specification download

Mooncell A704 Receiver Card Specification(Chinese)
Frequently asked questions
What is the A704 loading capacity for conventional and PWM drivers?
The specification lists 256 × 256 pixels for conventional drivers. With PWM drivers, maximum loading and brightness-corrected loading are 512 × 256, while chromaticity-corrected loading is 256 × 320.
Does A704 support HDR10 and HLG by itself?
HDR operation requires a compatible high-capacity independent controller and an HDR10 or HLG source. The receiving card is part of that display system; its HDR feature does not replace the required source and controller.
What is required to use the A704 3D function?
The manual calls for a receiving-card frame rate of 120 Hz and an independent controller that supports 3D. Enable the 3D function and set its parameters in the software or controller panel.
Is one-frame latency guaranteed for every module?
No. The specification qualifies the low-latency function for LED modules whose driver ICs have built-in RAM. It describes latency at the receiving-card end, not a guaranteed end-to-end delay for the complete video system.
What does 18Bit+ do?
The manual describes 18Bit+ as a software-enabled function that increases grayscale by four times to address grayscale loss at reduced brightness and low-gray correction artifacts. Check the display configuration and compatible components when applying it.




Reviews
There are no reviews yet.