4.5V 50A power supply for LED display cabinets
The South Creative NDC250HS4.5 supplies 4.5V DC at up to 50A for LED display modules. It uses synchronous rectification with efficiency up to 88% and natural air cooling.
This model has a 200–240V AC rated input range and a specified input range of 190–264V AC. Check the available mains supply before choosing it as a replacement, and observe the specification’s input-voltage and temperature derating curves.
Technical specifications
| Parameter | Specification |
|---|---|
| Model | NDC250HS4.5 |
| Nominal output | 4.5V DC / 50A |
| Output voltage range | 4.365–4.635V DC |
| Output current range | 0–50A; input-voltage and temperature derating apply |
| AC input range | 190–264V AC |
| Rated input range | 200–240V AC |
| Input frequency | 47–63Hz |
| Input current | 4.0A maximum at 220V AC, full load |
| Standby power | 5W maximum at 200–240V AC |
| Ripple and noise | ≤200mV peak-to-peak under the PDF test conditions |
| Efficiency | Up to 88% |
| Operating temperature | −30 to +70°C; derating required from 50 to 70°C |
| Storage temperature | −45 to +85°C |
| Operating humidity | 10–90% RH, non-condensing |
| Storage humidity | 10–90% RH |
| Altitude | Up to 3000m |
| Cooling | Natural air cooling |
| Protections | Input undervoltage, output overcurrent and output short circuit |
Values refer to the attached NDC250HS4.5 specification, revision V1.0 dated 11 October 2025. See the PDF for test conditions and detailed derating curves.
Check the cabinet before replacement
Match the output voltage to the LED modules and confirm the total current required. Compare the terminal layout and mounting points with the existing supply, and leave room for natural air cooling. For cabinets running above 50°C, use the specified temperature derating curve when deciding the load.
If the original model or wiring layout is unclear, contact LED-Mall with the unit label and module requirements.
Product image and specification download

Download Specification:
South Creative NDC250HS4.5 LED Display Power Supply Specification
Frequently asked questions
Can NDC250HS4.5 be connected to 110V AC?
110V AC is outside this model’s specified 190–264V AC input range. The rated input range is 200–240V AC; select a supply suited to the mains voltage at the installation.
What output voltage and current does it provide?
The nominal output is 4.5V DC, with current up to 50A. The document specifies an output voltage range of 4.365–4.635V and requires the relevant derating conditions to be observed.
Does the NDC250HS4.5 use fan cooling?
The specified cooling method is natural air cooling. Allow adequate ventilation and follow the temperature limits in the model-specific document.
What is the operating temperature range?
The specified operating range is −30 to +70°C. Derating is required from 50 to 70°C, so the highest operating temperature is not a full-load rating.
Where can I find the specification for this exact model?
The PDF download above identifies NDC250HS4.5, revision V1.0. Use it to check input limits, output characteristics, environmental conditions and derating before installation.




Reviews
There are no reviews yet.