Use this HUB43 pinout to check the signal required at each position on the mating module. Pins 1–12 carry R1/G1/B1 through R4/G4/B4. The remaining eight positions carry address, ground and control signals.
Connector pin assignments
| Pin | Signal | Pin | Signal |
|---|---|---|---|
| 1 | R1 | 2 | G1 |
| 3 | B1 | 4 | R2 |
| 5 | G2 | 6 | B2 |
| 7 | R3 | 8 | G3 |
| 9 | B3 | 10 | R4 |
| 11 | G4 | 12 | B4 |
| 13 | A | 14 | B |
| 15 | C | 16 | GND |
| 17 | CLK | 18 | GND |
| 19 | OE | 20 | LAT |
Board photo

Frequently asked questions
Where are the A, B and C address pins on the HUB43?
A is pin 13, B is pin 14 and C is pin 15. Pin 16 is ground.
What is the HUB43 clock pin?
CLK is pin 17, with ground on pins 16 and 18.
Are HUB43 and QP-HUB50(20) wired the same way?
No. For example, HUB43-V1.0 assigns OE to pin 19 and LAT to pin 20; QP-HUB50(20) lists LAT on 19 and OE on 20. Compare the full maps before choosing a replacement.




Reviews
There are no reviews yet.