NovaStar DH7508-S Receiving Card
The NovaStar DH7508-S is an LED display receiving card with 8 standard HUB75E connectors and up to 16 groups of parallel RGB data. It supports pixel-level brightness and chroma calibration, cabinet mapping, monitoring and loop backup.
Loading-capacity note: The earlier product description lists 256 × 256 pixels, while the attached DH7508-S specification V1.0.2 lists 512 × 384 at 60 Hz. Confirm the applicable hardware and firmware revision for your cabinet before relying on the higher figure. The PDF value is identified separately below.
Technical Specifications
| Parameter | Specification |
|---|---|
| Module connectors / RGB data | 8 × standard HUB75E / up to 16 parallel groups |
| Maximum resolution stated in V1.0.2 PDF | 512 × 384 at 60 Hz; see loading-capacity note above |
| Earlier listing resolution | 256 × 256 pixels; differs from the attached PDF |
| Input voltage | DC 3.8 V to 5.5 V |
| Rated current / power | 0.5 A / 2.5 W |
| Operating environment | −20°C to +70°C; 10% RH to 90% RH, non-condensing |
| Storage environment | −25°C to +125°C; 0% RH to 95% RH, non-condensing |
| Dimensions / net weight | 95.5 × 109.1 × 18.5 mm / 72.4 g per card |
| Listed certifications | RoHS; EMC Class A |
Actual current and power depend on settings, usage and environment. Use the linked PDF to check connector pin definitions and mounting details.
Calibration and Display Setup
Pixel-level brightness and chroma calibration works with NovaStar’s calibration system. Quick adjustment of dark or bright lines helps correct visible seams between modules or cabinets. The specification also lists RGB independent gamma adjustment and 3D output when paired with a sending card that supports 3D.
Calibration coefficients can be uploaded quickly. Mapping displays receiving-card numbers and Ethernet port information, and a stored image can be configured for startup, Ethernet disconnection or absence of a video signal.
Monitoring and Backup
The card monitors its own temperature and voltage and supports a cabinet LCD for temperature, voltage and runtime information. Ethernet bit-error detection and firmware readback require NovaLCT V5.2.0 or later. Configuration parameters can also be read back to a local computer.
Loop backup connects the sending card and receiving cards through primary and backup lines. Dual program backup stores two firmware copies to assist recovery from an abnormal update.
Product Images and Specification PDF


Download the NovaStar DH7508-S specification (PDF)
Frequently Asked Questions
How many HUB75E connectors does the DH7508-S have?
It has 8 standard HUB75E connectors and supports up to 16 parallel RGB data groups.
Is the DH7508-S loading capacity 256 × 256 or 512 × 384?
The earlier listing states 256 × 256 pixels, but the attached V1.0.2 PDF states 512 × 384 at 60 Hz. Confirm the hardware and firmware revision for the supplied card and your cabinet configuration before choosing the loading resolution.
Does the DH7508-S support brightness and chroma calibration?
Yes. The attached specification describes per-pixel brightness and chroma calibration using NovaStar’s calibration system.
Which NovaLCT version is required for firmware readback?
The attached specification requires NovaLCT V5.2.0 or later for firmware readback and Ethernet bit-error detection.
Can the DH7508-S display a stored image after signal loss?
Yes. The specification supports a pre-stored image for startup, Ethernet disconnection or when no video signal is available.







Reviews
There are no reviews yet.