Use the pin-one mark to orient the connector. The map begins with RD1 and GD1 on pins 1 and 2. Data labels in this definition run from RD1 on pin 1 to BD4 on pin 12.
Connector pin assignments
| Pin | Signal | Pin | Signal |
|---|---|---|---|
1 | RD1 | 2 | GD1 |
3 | BD1 | 4 | RD2 |
5 | GD2 | 6 | BD2 |
7 | RD3 | 8 | GD3 |
9 | BD3 | 10 | RD4 |
11 | GD4 | 12 | BD4 |
13 | CLK | 14 | LAT |
15 | OE | 16 | GND |
Frequently asked questions
Where are the control signals on HUB94A?
CLK on pin 13, LAT on pin 14, OE on pin 15. Match these labels against the mating connector before installing the board.
Which positions are marked ground?
The interface definition marks 16 as GND. Check the connector orientation before counting pin positions.
How can I check whether my module matches this card?
Compare each numbered signal with the module documentation, including data order, control signals and ground. Connector size alone cannot establish the wiring.




Reviews
There are no reviews yet.