Huidu HD-R3210 at a glance
The 후이두 HD-R3210 is an LED receiving card for synchronous and asynchronous control systems. It offers 10개의 온보드 HUB320F 인터페이스, 40 parallel RGB data groups or 120 serial data groups, and Gigabit Ethernet communication.
The specification table lists a maximum load of 512 × 512 픽셀, 60Hz; usable loading depends on the module resolution and interfaces used.
Check the module layout before selecting a card
The specification overview describes capacity as up to 260,000 pixels, while its table gives 512 × 512 pixels at 60 Hz. Treat these as the document’s rounded overview and tabulated maximum, rather than separate capacity modes. Confirm the planned module layout and sender configuration before calculating card quantities.
HD-R3210 connections and loading
| 매개 변수 | 사양/기능 |
|---|---|
| 모델 | Huidu HD-R3210(R3210) LED 디스플레이 수신 카드 |
| 제어 시스템 | 동기식 및 비동기식 LED 디스플레이 제어 시스템 |
| 모듈 인터페이스 | 10개의 온보드 표준 HUB320F 인터페이스 |
| 데이터 출력 | 40개의 병렬 RGB 데이터 그룹 또는 120개의 직렬 데이터 그룹 |
| 지원되는 전송 유형 | 듀얼 모드 송신 박스, 비동기 송신 카드, 동기 송신 카드 및 Huidu VP 시리즈 비디오 프로세서 |
| 지원되는 모듈 | 일반적인 드라이버 IC 모듈 및 대부분의 PWM 드라이버 IC 모듈; 선택 전에 특정 모듈 및 IC를 확인하십시오. |
| 주사 방법 | 1/128 스캔까지 정적 디코딩을 지원하며, 포인트 추출 및 빈 포인트 설정을 지원합니다. 사양에 따르면 138 시리즈 디코딩은 1/8 스캔 이상(138, 5166, 5266, 2012, 2013, 7258, 32019)을 지원하지 않습니다. |
| 통신 방법 | 기가비트 이더넷 |
| 최대 적재 능력 | 512 × 512 픽셀, 60Hz; 실제 부하는 모듈 해상도 및 사용된 인터페이스에 따라 달라집니다. |
| Module configuration reference | P1.25 modules × 8; ≥ P1.5 modules × 10, as listed in the specification. Confirm the actual module dimensions and resolution. |
Configuration, correction and monitoring
| 매개 변수 | 사양/기능 |
|---|---|
| 멀티 카드 연결 | 수신 카드는 후이두에서 지정한 나노초 수준의 동기화를 통해 어떤 순서로든 배열할 수 있습니다. |
| 그레이 스케일 | 256~65,536 레벨 |
| 스마트 설정 | 스마트 구성 및 화면 레이아웃 설정은 다양한 모듈 배열을 지원합니다. |
| 테스트 기능 | 화면 밝기 균일성 및 LED 모듈 평탄도 확인을 위한 내장형 화면 테스트 기능 |
| 통신 거리 | 설명서에 명시된 대로 Super Cat5 또는 Cat6 네트워크 케이블을 사용하여 80m 이내에서 사용 가능합니다. |
| 이미지 회전 | 0°, 90°, 180° 및 270° |
| 포인트별 수정 | 점 단위 밝기 및 색상 보정, 명암선 조정, 이음새 보정을 위한 그레이스케일 보정 시스템과 함께 작동합니다. |
| 독립적인 RGB 감마 조정 | 불균일한 저채도 성능 및 화이트 밸런스 편차를 해결하기 위해 R, G, B 감마를 개별적으로 조정합니다. |
| 모듈 플래시 | 보정 계수는 플래시 메모리가 장착된 모듈에 저장하고 다시 읽어올 수 있습니다. |
| 미리 저장된 화면 | 전원이 켜진 상태, 네트워크 케이블이 분리된 상태 또는 비디오 소스 신호가 없는 상태와 같은 상황에서 미리 설정된 화면을 표시합니다. |
| 모니터링 기능 | 외부 장비 없이 수신 카드의 온도와 전압을 모니터링하고 작동 시간을 기록합니다. |
| 구성 매개변수 백업 | 매개변수는 공장 영역에 저장하고 변경 후 해당 영역에서 복원할 수 있습니다. |
| 프로그램 백업 | 비정상적인 프로그램 업데이트로 인한 시스템 멈춤 현상을 방지하기 위해 두 개의 펌웨어 프로그램이 출하 전에 수신 카드에 저장됩니다. |
호환성 체크리스트
- Match the module’s HUB320F connection and pinout.
- Check the driver IC, decoding method and scan ratio.
- Calculate the pixel load and number of interfaces required for each cabinet.
- Confirm compatibility with the sending card, sending box or VP-series processor in the system.
- For a replacement, compare the existing card and retain the correct screen configuration.
Scan compatibility needs a separate check. Static to 1/128 scan support does not establish compatibility with every module. The supplied specification states that 138-series decoding does not support 1/8 scan or above, listing 138, 5166, 5266, 2012, 2013, 7258 and 32019. Confirm the actual module with our team before ordering.
찾아보기 LED 수신 카드 범위 if your module needs a different interface.
Original HD-R3210 product image

사양 다운로드
HD-R3210 Product Specifications V1.0 (PDF)
Check the matching document, actual board revision and module configuration for installation decisions.
자주하는 질문
How many HUB interfaces does the HD-R3210 have?
It has 10 onboard HUB320F interfaces. Match the connector, pinout and LED module configuration before choosing a receiving card.
Is 512 × 512 pixels a guaranteed load for every module?
No. The specification lists a maximum of 512 × 512 pixels at 60 Hz, while its overview uses the rounded figure of 260,000 pixels. Actual loading depends on the interfaces used and module resolution.
Can it work with synchronous and asynchronous systems?
The specification supports both types of LED display control system, including supported Huidu sending cards, dual-mode sending boxes and VP-series video processors. Confirm the particular sender and configuration.
Does static to 1/128 scan mean every driver IC is supported?
No. Check the module driver IC and decoding method. The specification includes a separate restriction for 138-series decoding; do not infer compatibility from the general scan range alone.
What information should I send before ordering?
Send the LED module resolution, HUB connection and pinout, driver IC, scan method, cabinet layout and sending-device model. For a replacement, include photos of the existing receiving card.
Need help matching your receiving card?
Send module photos, driver-IC details, pixel dimensions and the sending-device model through WhatsApp 또는 우리 연락처 페이지 for compatibility assistance.
Product listing reviewed on 16 November 2026 by LED-Mall. Specifications follow the linked product document; actual loading depends on system configuration.




후기
리뷰는 아직 없습니다.